Material Stainless Steel AISI 304, 0.8 mm thickness and transparent part in tempered glass
IP Rating IP66/ 67
Operating Temperature -30° C to + 55° C
Standards Compliance with Electromagnetic Compatibility ( EMC) according to European Directive 89/ 336/ EC
Ex-code Industrial waterproof IP65 CLASS I
Gaskets Special cross section tightness gasket, silicon rubber made ( close cells) located in housing channel between body and window frame.
Entries Body complete of two diam. 21mm through holes for cable entries, one complete of metallic plug with lock nut and gasket, and the other one with plastic plug for dust protection.
Hardware and Screw AISI 304 Stainless Steel external hardware and screws
Lamps RMS Series is suitable for two pins fluorescent lamps G13 socket PHILIPS TL-D
Lamps Wattage 18 / 36 W
Ballast Electromecanichal ballast

Rated operation voltage ( UE) 230 V
Frequency
50 Hz
Power factor > 0, 9
Accessories Wiring with High frequency electronic ballast ( 220-240V 50/ 60 Hz.)
Available Suspension mounting kit “ G1” AISI 04 madePole mounting kit “ P12” 1 ½ ” size AISI 304 made
upon request Wall mounting kit “ H1” AISI 304 made
Emergency Service RMS 540 lighting fixtures for Emergency Service are available: Ø RMS 540...LE-P

Note Very low pollution at the end of operative life time of lighting fixtures. The inorganic materials used for RMS, like stainless steel and glass, allow a recycle of 95% , only electrical components and insulation of single core wires need some more care. No through holes between inside and outside of luminaries, out of holes for power supply cable whatever protected by a suitable waterproof cable gland ( on request) . Therefore, during the time, release would be possible where, for fixing devices, there are through holes and relevant gaskets.